2009 — Removal

HOME C.1 ABS MODULE 7. See Figure C-2 . Remove top left mount bracket (3) from battery tray floor. Figure C-1. Battery and Tray Components 8. Evacuate brake fluid from brake system. 9. See Figure C-3 . Disconnect ABS module electrical con- nector. NOTE Note location and routing of all brake lines as they attach to ABS module. 10. Remove all brake lines from ABS module. 11. Remove screws (1) and ABS top mount bracket (2) from ABS module. 12. Remove ABS module from motorcycle. 2009 VRSC Service: Appendix C ABS C-1 sm04752 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding.

(00251b) NOTE The ABS module consists of the hydraulic control unit (HCU) and the electronic control unit (ECU).These parts are not sold 13 separately. Failure of either unit requires replacement of the ABS module. 8 1 1. Remove main fuse. See 7.4 MAXI-FUSE. 11 2. Remove air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM. 3. Remove air box. 4. Disconnect battery, remove all clipped connectors from battery caddy, and disconnect and remove starter solenoid. See 1.6 RADIATOR SIDE COVERS. 5. See Figure C-1. Remove battery and tray components from motorcycle. a. Remove positive (4) and negative (13) battery cables. b. Remove strap (1). 1. Strap c. Remove battery (6) from motorcycle. 2. Boot 3.

Term d. Remove left side battery caddy (5) and right side 4. Posit battery caddy (11). 5. Batte e. Remove fasteners (7, 8) and remove battery tray (9) 6. Batte from motorcycle. 7. Scre 8. Nut ( 6. Remove radiator side panels and radiator shroud. See 9. Batte 1.6 RADIATOR SIDE COVERS. 10. Batte 11. Batte NOTE 12. Scre Cover any remaining painted areas to protect them from contact 13. Nega 1 2 5 3 3 4 2 6 7 10 8 8 9 inal screw (2) ive cable to solenoid ry caddy (left side) ry w 3) ry tray ry tray pad ry caddy (right side) w tive cable