HOME sm04662 2 INSTALLATION 1 TOOL NAME PART NUMBER DIGITAL TECHNICIAN II HD-48650 5 1 BASIC VACUUM BRAKE BLEEDER SNAP-ON BB200A 3 4 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. See Figure C-2 . Insert ABS module into head cavity of motorcycle frame. 2. Loosely install all ABS module fasteners. Do not tighten fasteners at this time. 6 7 NOTE Connect brake lines to ABS module at correct ports exactly as noted upon disassembly. 1. Screw (5) 2. ABS top mount bracket 3. ABS left mount bracket 4. Nut 5. Washer 6. ABS module cover 7. ABS module 3.
Using new copper washers, attach brake lines to ABS module at correct ports exactly as noted upon disas- sembly.Tighten banjo bolts to 17-20 Nm (12.5-14.7 ft-lbs). 4. Final tighten ABS module fasteners to 4-6 Nm (35-53 in- lbs ). Figure C-2. ABS Module 5. See Figure C-1 . Install battery tray components and bat- tery. sm04880 a. Insert battery tray (9) into frame. b. Install battery tray with nuts (8) and fastener (7) as shown. Tighten fasteners to 6-10 Nm (53-88 in-lbs ). c. Install left side battery caddy (5), right side battery caddy (11), battery (6) and strap (1). d. Install battery cables. e. See Figure C-3 . Connect ABS module plug to ABS module. 6.
Install starter solenoid to battery tray. See 7.9 STARTER SOLENOID . 7. Connect starter solenoid cables and wire. 8. Install all clipped connectors to their original positions on battery tray. 9. Fill and bleed air from brake system. Figure C-3. ABS Module Plug 10. Install air box and air box cover. 11. Install main fuse. 12. Obtain BASIC VACUUM BRAKE BLEEDER (Part No. Snap-On BB200A) or equivalent tool. Add brake fluid and bleed brake system. 13. Connect motorcycle to DIGITAL TECHNICIAN II (Part No. HD-48650) and confirm that brake system is both properly connected and bled. C-2 2009 VRSC Service: Appendix C ABS