HOME C.2 WHEEL SPEED SENSOR FRONT WHEEL SPEED SENSOR Removal sm04508 2 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1 1. Remove Maxi-Fuse.See 7.4 MAXI-FUSE . 2. Remove both radiator side covers. See 1.6 RADIATOR SIDE COVERS . 3. Remove axle nut per procedure and slide front axle out far enough for wheel speed sensor to be removed from position. See 2.23 FRONT WHEEL . 1. ABS Sensor Cable Clip 2. ABS Sensor Cable Clip Bracket 4. Remove ABS sensor cable clip (1) from bracket (2). See Figure C-6 . Figure C-4. ABS Sensor Cable Clip 5. Locate hose clips and disconnect sensor cable from brake hose. See Figure C-5 .
etc.) or damage will occur. Figure C-5. ABS Sensor Cable to Brake Hose Clips 1. Install wheel speed sensor, slide front axle into place and pivot wheel speed sensor upward until tab stops sensor 2. 3. 4. 5. 6. 7. 6. Disconnect ABS connector and remove wheel speed sensor from motorcycle. See Figure C-4. Installation To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) NOTE • Never pull wheel speed sensor cable tight or use to retain wheel, axle or other components.
• Always keep wheel speed sensor (and ABS encoder bearing) away from magnetic fields (such as magnetic parts trays, magnetic base dial indicators, alternator rotors, sm04514 on fork leg. sm04511 Tighten front axle nut according to procedure. See 2.23 FRONT WHEEL. Install ABS sensor clip as shown. See Figure C-6. Connect ABS wheel speed sensor connector. See Figure C-4. Install ABS cable clips as shown. See Figure C-5. Install both radiator side covers. See 1.6 RADIATOR SIDE COVERS. Install Maxi-Fuse. See 7.4 MAXI-FUSE. Figure C-6. Front ABS Connector Location 2009 VRSC Service: Appendix C ABS C-3 covers. See 1.6 RADIATOR SIDE 7.4 MAXI-FUSE. Figure C-6.
Front ABS Con 2009 VRSC Service nector Location : Appendix C ABS C-3