2009 — Rear Wheel Speed Sensor

HOME REAR WHEEL SPEED SENSOR sm04515 Removal To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove main fuse. See 7.4 MAXI-FUSE . NOTE Note routing of all cable ties and clips before removal. Install cable ties and clips in exact locations as removed. 2. See 2.26 REAR WHEEL . Remove axle nut per procedure and slide axle out far enough for wheel speed sensor to be removed from position. Figure C-7. Rear ABS Sensor Cable to Brake Hose Clips 3. See Figure C-7 .

Locate hose clips and disconnect sensor bearing) away from magnetic fields (such as magnetic parts trays, magnetic base dial indicators, alternator rotors, etc.) or damage will occur. Figure C-8. Rear ABS Connector Location 1. See Figure C-9 . Install wheel speed sensor, slide axle into place and pivot wheel speed sensor upward until locator stops sensor from moving further. sm04510 2. See 2.26 REAR WHEEL . Tighten axle and verify belt tension according to procedure. 3. See Figure C-8 . Mate ABS wheel speed sensor connector. 4. See Figure C-7 . Install ABS cable clips as shown. 5. Install main fuse. See 7.4 MAXI-FUSE . Figure C-9. ABS Sensor Locator C-4 2009 VRSC Service:

Appendix C ABS cable from brake hose. 4. See Figure C-8. Disconnect ABS connector and remove wheel speed sensor from motorcycle. Installation To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) NOTE • Never pull wheel speed sensor cable tight or use to retain wheel, axle or other components. sm04512 retain