2009 — ABS Module to Front Brake Calipers

HOME C.3 ABS BRAKE LINES FRONT MASTER CYLINDER TO ABS MODULE 8. Install main fuse. 9. Install side covers. TOOL NAME PART NUMBER 10. and bleed front brake system. DIGITAL TECHNICIAN II HD-48650 Removal BASIC VACUUM BRAKE BLEEDER SNAP-ON BB200A 11. Connect motorcycle to DIGITAL TECHNICIAN II (Part No. HD-48650) and confirm that front brake system is both properly connected and bled. from MF port of ABS module. Discard washers. Figure C-10. Front Master Cylinder to ABS Module Brake Line 8. Loosen ABS module fasteners to allow brake line clear- ance during disassembly. 9. Remove banjo bolt (2) to release brake line from master cylinder. Discard washers (3).

ABS MODULE TO FRONT BRAKE CALIPERS 10. Remove brake line (4) from motorcycle, using caution to avoid spilling any residual brake fluid on finished surfaces. TOOL NAME PART NUMBER Installation DIGITAL TECHNICIAN II HD-48650 1. Route new brake line as original brake line was routed. BASIC VACUUM BRAKE BLEEDER SNAP-ON BB200A 2. Install lower end of brake line to ABS module with banjo bolt and new washer. Removal 3. Tighten banjo bolt to master cylinder to 17-20 Nm (12.5- 14.7 ft-lbs). To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- 4. banjo bolt and new 5. ft-lbs). . 6. 7. btain BASIC VACUUM BRAKE BLEEDER (Part o.

Snap-On BB200A) or equivalent tool. Add brake fluid sm047 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove side covers. 2. Remove main fuse. See 7.4 MAXI-FUSE. 3. Remove air box cover assembly. See 1.5 AIR CLEANER AND EXHAUST SYSTEM. 4. Disconnect and remove battery. See 1.9 BATTERY MAINTENANCE. 5. Remove starter solenoid from clip on plastic battery tray and remove plastic battery tray from motorcycle. NOTE Cover any remaining painted areas to protect them from contact with brake fluid during the removal and installation procedures. 1. 6. Drain front brake system. 2. NOTE 3.

Note location and routing of brake line prior to removal. 4. 5. 7. See Figure C-10. Remove banjo bolt to release brake line 23 5 4 3 1 2 ABS module cover Bolt Washer Front master cylinder to ABS module brake line ABS module ke line to front master cylinder with ceeding. (00251b) shers. 1. Remove main fuse. See S module to 17-20 Nm (12.5-14.7 2. Remove left side cover. steners to 4-6 Nm (35-53 in-lbs). N Cover any exposed painted a onents. Install and connect battery. with brake fluid during the re 2009 VRSC 7.4 MAXI-FUSE OTE reas to protect th moval and installa Service: Appen