2009 — ABS Module to Front Brake Calipers

HOME 3. 4. 5. 6. 7. 8. 1. 2. 3. 4. 5. 6. 7. 8. Drain front brake system. sm04724 1 NOTE 2 position and routing of brake lines, clips and wire ties to removal. Remove clips (6) from brake hose/ABS sensor cables. Remove wire ties. See Figure C-11. Remove banjo bolt (4) to release brake line from F port of ABS module. Discard washers (3). Remove complete bleeder screw assemblies (8) to release brake lines from front calipers. Discard washers (3). Remove screw (7) and remove brake line assembly from motorcycle. 4 tallation Route new brake line as original brake line was routed. Install lower end of brake line (5) to calipers using bleeder screw assemblies (8) and new washers (3).

3 Tighten bleeder screw assemblies to 23.0-26.0 Nm (17.0- 3 19.2 ft-lbs). Install wire ties removed during disassembly. Install screw (7) and tighten to 6-10 Nm (53.0-88.4 in-lbs). 5 Tighten banjo bolt to ABS module to 17.0-20.0 Nm (13.0- 14.7 ft-lbs). Obtain BASIC VACUUM BRAKE BLEEDER (Part No. SNAP-ON BB200A) or equivalent tool. Add brake fluid and bleed front brake system. 6 Connect motorcycle to DIGITAL TECHNICIAN II (Part No. HD-48650) and confirm that front brake system is both properly connected and bled. 7 8 3 3 1. ABS module 2. ABS module cover 3. Copper washer 4. Bolt 5. ABS module to front calipers brake line 6. Clip 7. Screw 8. Bleeder screw assembly Figure C-11.

ABS Module to Front Brake Calipers Brake Like 2009 VRSC Service: Appendix C ABS 8. Bleeder screw assembly Figure C-11. ABS Module to Fro Like : Appendix C ABS nt Brake Calipers Brake BASIC VACUUM BR AKE BLEEDER alent tool. Add bra DIGITA L TECHNICIAN I