2009 — ABS Module to Rear Brake Caliper

HOME REAR MASTER CYLINDER TO ABS MODULE 9. If more than one brake line was removed: a. Confirm that brake system is properly connected. To accomplish this, install master cylinder reservoir cover, connect motorcycle to DIGITAL TECHNICIAN II (Part No. HD-48650) and perform "ABS Service" procedure in the "Toolbox" menu. TOOL NAME PART NUMBER DIGITAL TECHNICIAN II HD-48650 Removal b. Repeat bleeding procedure if brakes still feel spongy. 1. See Figure C-12 . Install new brake line exactly as original brake line was routed. Figure C-12. ABS Module To Rear Master Cylinder 2. Start banjo bolt (5) with new washers (3) to secure brake line to MR port of ABS module.

ABS MODULE TO REAR BRAKE CALIPER NOTE If installing a new stop lamp switch, apply Loctite Pipe Sealant with Teflon 565 to threads and start threading switch into rear TOOL NAME PART NUMBER DIGITAL TECHNICIAN II HD-48650 Removal 3. Start banjo bolt (5) with new washers (3) to secure brake line to rear master cylinder. 4. Tighten banjo bolt to master cylinder to 23-29 Nm (17-21.4 ft-lbs). To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- 5. ft-lbs). 6. 7. 8. BRAKES . sm04887 To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1. Remove main fuse.

See 7.4 MAXI-FUSE. NOTE Cover any exposed painted areas to protect them from contact with brake fluid during the removal and installation procedures. 2. Drain rear brake system. NOTE Note location and routing of brake line prior to removal. 3. See Figure C-12. Remove banjo bolt to remove brake line from MR port of ABS module. Discard washers. 4. Disconnect wiring lead from stop lamp switch (4). 5. Remove cover and empty master cylinder reservoir. 6. Remove banjo bolt to release brake line from master cyl- inder. Discard washers. 7. Remove any cable straps (7) retaining brake line and remove brake line from motorcycle. Installation 1. ABS m 2. ABS m 3. Copper 4.

Stoplig To prevent accidental vehicle start-up, which could cause 5. Bolt death or serious injury, remove main fuse before pro- 6. ABS m ceeding. (00251b) 7. Cable s 1 2 3 4 5 3 6 7 5 odule odule cover washer ht switch odule to rear master cylinder brake line trap 16.3-20.3 Nm (12-15 ft-lbs ceeding. (00251b) S module to 17-20 Nm (12.5-14.7 1. Remove main fuse. See 1.6 R onnector on brake lamp switch. 2. Remove right side radiator SIDE COVERS. iously removed. system. See 1.12 BLEEDING 2009 VRSC Servi ADIATOR SIDE COVERS. cover. See 1.6 RADIATOR ce: Appendix C ABS C-7