2009 — ABS Module to Rear Brake Caliper

HOME NOTE Cover any exposed painted areas to protect them from contact with brake fluid during the removal and installation procedures. NOTE Note location and routing of brake line prior to removal. 3. Drain rear brake system. 6. See Figure C-13 . Remove banjo bolt to remove brake line from R port of ABS module. Discard copper washers. 4. Remove cover and empty master cylinder reservoir. 7. Remove banjo bolt to release brake line from rear caliper. Discard copper washers. 5. Remove exhaust system from motorcycle. See 4.14 EXHAUST SYSTEM:VRSCAW . See 4.16 EXHAUST SYSTEM: VRSCF . See 4.15 EXHAUST SYSTEM: VRSCDX . 8. Remove any cable straps (7) and clips (8) retaining brake line. 9.

Remove clamp and fastener (9). 10. Remove brake line (5) from motorcycle. sm04888 1 2 4 3 5 3 4 8 9 6 7 6. 1. Retainer (2) ABS module 2. 7. ABS module cover Cable strap 8. 3. Clip Bolt 4. 9. Copper washer Clamp and fastener 5. ABS module to rear brake caliper brake line Figure C-13. ABS Module To Rear Brake Caliper Brake Line Installation 2. See Figure C-13 . Start banjo bolt (3) with new copper washers (4) to secure brake line to R port of ABS module. 3. Start banjo bolt (3) with new cop brake line to rear brake caliper. ause pro- 4. Install any cable straps (7) and disassembly. was 5. Install clamp and fastener (9). 6.

Tighten banjo bolt to caliper to per wash clips (8) To prevent accidental vehicle start-up, which could c death or serious injury, remove main fuse before ceeding. (00251b) 1. Install new brake line exactly as original brake line routed. C-8 2009 VRSC Service: Appendix C ABS 23-29 Nm