HOME sm00945 VERIFY CAM TIMING TOOL NAME PART NUMBER CRANKSHAFT ROTATING WRENCH HD-45314 TDC POSITIONING TOOL HD-45653 1. See Figure 1-79 . Install TDC POSITIONING TOOL (Part No. HD-45653) in front spark plug hole. NOTE Never insert a foreign object, such as a screwdriver in the spark plug hole. Engine damage can result. 2. Remove derby cover. Figure 1-76. Camshaft Toe Spalling (typical) Rotate engine toward front cylinder only. Do not rotate engine toward rear cylinder, as engine damage can result. (00409c) Figure 1-77. Camshaft Heel Spalling positioned as illustrated. NOTE NOTE Copper colored links (1) are only used in installation of cam chains.
They may not appear in the positions illustrated. If camshaft lobe exhibits spalling that extends fully across the width of the camshaft lobe or extends past 15 mm (.59 in.) beyond the toe of the camshaft lobe in either direction of camshaft travel, replace camshaft. 6. Install derby cover. ANKSHAFT ROTATING WRENCH (Part No. HD- sm00959 45314) rotate the en tion of operation) a when exhaust valv extend as valve clos 4. Verify that the TDC P and front piston is a 5. See Figure 1-80. Not and cam lobe posit correct when: a. The front exhau are aligned. b. The front exha positioned as ill c. The rear intake are aligned. ate the en gine counterclockwise (CCW) (direc- sm01847 Figure 1-78.
Cam Lobe (typical) showing 15 mm from toe of camshaft lobe on each side of lobe 2009 VRSC Ser Figure 1-78. Cam Lob of camshaft