200u7.book

English TM-U200 Series User’s Manual / Bedienungsanleitung Gebruikershandleiding / Manuel d’utilisation Manual do utilizador / Manual del usuario Manuale dell’utente 401391301 TM-U200 Series User’s Manual -1

Page 1

DIP Switch Tables

Printer Parts 2 3 Type B and two color Type D Single color Type D DIP Switch Tables Serial Parallel SW 1-1 1-2 1-3- 1-7 1-8 2-1 7 9 2-2 2-3 2-4 2-5, 2-6 2-7 2-8 1 Type A SW F unction ON OFF 1-1 D e ata receptio rror n Ignored Prints”?” 1-2 R c eceive buffer apacity 40 bytes ANK Model: 1000 bytes Multilingual model: 512 bytes 1-3 H andshaking XON/XOFF DTR/DSR 1-4 Word length 7 bits 8 bits 1-5 P arity check Yes No 1-6 P arity selection Even Odd 1-7 B aud rate 4800 bps 9600 bps 1-8 B usy condition BUSY when receive buffer is full BUSY when offline or receive buffer full 2-1 P s 7 9 rint column election × 9 font/ × 9 font 42/35 40/33 2-2 F or internal use. Do not change.

2-3 T T r ype A For internal use. Do not change. ypes B & D Pin eset signal 6 Enabled Disabled 2-4 T T r ype A Undefind. ypes B & D Pin eset signal 25 Enabled Disabled 2-5, F 2-6 or internal use. Do not change. 2-7 T s T ype A Pin 6 re ignal set Enabled Disabled ypes B & D For internal use. Do not change 2-8 T ype A Pin 25 Enabled Disabled r T eset signal ypes B & D Undefined. nction ON OFF to line feed Enabled Disabled ceive buffer pacity 40 bytes ANK Model: 1000 bytes Multilingual model: 512 bytes defined sy condition BUSY when receive buffer is full BUSY when offline or receive buffer full nt column lection × 9 font/ × 9 font 42/35 40/33 ernal use. Do not change. pe A Internal use.

Do not change. pes B & D Undefined. pe A Undefined. pes B & D Pin reset signal Enabled Disabled r internal use. Do not change. pe A Undefined. pes B & D Internal use. Do not change. pe A Pin 31 set signal Enabled Disabled pes B & D Undefined.

Page 2

EMC and Safety Standards Applied

English All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the information contained herein. While every precaution has been taken in the preparation of this book, Seiko Epson Corporation assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein.

Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s operating and maintenance instructions. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko Epson Corporation.

EPSON and ESC/POS are registered trademarks of Seiko Epson Corporation. NOTICE: The contents of this manual are subject to change without notice. Copyright © 2001 by Seiko Epson Corporation, Nagano, Japan. EMC and Safety Standards Applied Printer CE Marking Product Name: TM-U200A/TM-U200B/TM-U200D Model Name: M119A/M119B/M119D The following standards are applied only to the printers that are so labeled. (EMC is tested using the packaged AC adapter and PS-170.) Europe: CE marking Safety: EN 60950 North America: EMI: FCC/ICES-003 Class A Safety: UL 1950/CSA C22.2 No. 950 Japan: EMC: VCCI Class A Oceania: EMC: AS/NZS 3548 Class B Taiwan: EMC:

Class B AC Adapter The printer conforms to the following Directives and Norms: Directive 89/336/EEC EN 55022 Class B EN 55024 IEC 61000-4-2 IEC 61000-4-3 IEC 61000-4-4 IEC 61000-4-5 IEC 61000-4-6 IEC 61000-4-11 Directive 90/384/EEC EN 45501 FCC Compliance Statement For American Users This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. FOR CANADIAN USERS Product Name: PA-6511/6513, PB-6509/6510 Model Name: M34PA, M34PB The following standards are applied only to the AC adapters that are so labeled. (The printer and the AC adapter together are applied to the EMC standards.) Europe: CE marking Safety: EN 60950 North America: Safety:

UL 1950/CSA C22.2 No. 950 Japan: Safety: Electrical Appliance and Material Control Law of Japan Oceania: Safety: AS 3260 WARNING The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by SEIKO EPSON Corporation could void your authority to operate the equipment. This Class A digital apparatus complies with Canadian ICES-003. TM-U200 Series User’s Manual 1

Page 3

Safety Precautions

English Safety Precautions This section presents important information intended to ensure safe and effective use of this product. Please read this section carefully and store it in an accessible location. WARNING: Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise. Continued use may lead to fire. Immediately unplug the equipment and contact your dealer or a SEIKO EPSON service center for advice. Never attempt to repair this product yourself. Improper repair work can be dangerous. Never disassemble or modify this product. Tampering with this product may result in injury or fire. Be sure to use the specified power source.

Connection to an improper power source may cause fire. Do not allow foreign matter to fall into the equipment. Penetration by foreign objects may lead to fire. If water or other liquid spills into this equipment, unplug the power cord immediately, and then contact your dealer or a SEIKO EPSON service center for advice. Continued usage may lead to fire. CAUTION: Do not connect cables in ways other than those mentioned in this manual. Different connections may cause equipment damage and burning. Be sure to set this equipment on a firm, stable, horizontal surface. The product may break or cause injury if it falls. Do not use in locations subject to high humidity or dust levels.

Excessive humidity and dust may cause equipment damage or fire. Do not place heavy objects on top of this product. Never stand or lean on this product. Equipment may fall or collapse, causing breakage and possible injury. To ensure safety, unplug this product before leaving it unused for an extended period. 2 TM-U200 Series User’s Manual

Page 4