Electrical connection Fitting the extractor hood 3. Connect the brown (Live) wire to the terminal marked ‘L’, or coloured red. The extractor hood may be connected to a correctly installed earthed socket only. Attach the earthed socket near the extractor hood in an accessible position. ❑ The earthed socket should be connected via its own power circuit. If appliances do not feature the OFF delay function, the indicator may start flas- hing when the extractor hood has been switched off for several hours via a separa- te switch, even though the grease filters are not yet saturated. (See instructions for use, section on filter and maintenance). 60 cm wide extractor hood: With 3 screws.
598 100 21 102 57 140 127 536 180 90 cm wide extractor hood: With 5 screws. 21 898 100 Electrical specifications: These can be found on the rating plate inside the appliance following removal of the filter frames. Before carrying out repairs, always isolate the appliance. Length of the connection cable: 1.30 m. If permanent connection is required: The extractor hood may only be connected by an electrician registered with the local electricity board. A disconnecting device must be provided on the installation side. Switches with a contact opening of more than 3 mm and all-pole disconnection are regarded as disconnecting devices. These include LS switches and contactors.
This extractor hood complies with EU regulations on interference suppression. 102 57 127 140 180 536 836 1. Mark mounting boreholes. Dimensions can be found in or use template. 2. Drill 8 mm dia. holes and insert wall plugs flush with the wall. 3. Screw in the upper screws (on left and right) until there is a gap of approx. 7 mm between the screw head and the wall. Fitting the extractor hood To the wall 50 cm wide extractor hood: With 3 screws. 100 21 498 4. Remove the filter grille (see Instructions for use) 5. Attach the extractor hood. 6. Tighten the lower screw (with washer) inside the extractor hood. 102 57 140 127 436 180 26