3. Remove the filter, and use the cleaning tool to clean the dust compartment and the filter, and then wash them with clean water. Install the dust compartment and the filter back afer fully drying them. Brush 1. Flip the vacuum-mop over and press and hold the two release butons to remove the brush cover. 2. Remove the brush upwards. 3. Pull out the brush bushing. 4. Rotate the brush holders until the alignment mark on each holder is aligned with the unlocking mark, and then remove the brush holders from both ends of the brush. 5. Use the blade of the cleaning tool to cut the hair tangled on the brush and thoroughly clean the brush. 6. Reinstall the brush holders and the brush bushing. 7.
Reinstall the brush and the brush cover, and press the brush cover securely into place. Note: It is recommended to thoroughly clean the dust compartment at least once a week. Make sure to fully dry the dust compartment and the filter before use (at least dry them for 24 hours). Locking Mark Brush Cover Release Buton Locking Mark Water Tank Simultaneously press and hold both the release butons of the water tank, and then slide it out from the botom of the vacuum-mop as illustrated. Brush Brush Bushing Alignment Mark Brush Holders Alignment Mark Unlocking Mark Unlocking Mark Water Tank Release Buton Note:
Afer mopping, immediately remove the water tank, empty out any remaining water, and clean and dry the mop pad to prevent lingering odor and mildew. 14