214 F3B ENGINE T RAKKER E URO 4/5 PRINT603.93. 641/A Fitting the cylinder head the T.D.C. 60515 whenever removing the cylinder (1) and tighten the screws as of the screws with engine oil 61270 of the screws fixing the and 60565 Key wrench (1): Base q November 2006 Print 603.93.641/A Revi - June 2007 Figure 179 47594 Figure 182 Check that the pistons 1-6 a Put the gasket (2) on the cra NOTE Use new screws w head. Mount the cylinder head ( shown in Figs. 183, 184 and NOTE Lubricate the thread before assembly. Figure 183 Diagram of the tightening seq cylinder head. Figure 184 - Pre-tightening with the t 1st phase: 60 Nm (6 kgm 2nd phase:
120 Nm (12 k OTE Before reusing the screws (2), measure the diameter of the thread; it must be no less than 13.4 mm; if it is, change the screw. Lubricate the thread of the screws with engine oil before assembly. nnect the connecting rods to the relevant pins of the nkshaft, mount the connecting rod caps (1) together with bearing shells. Tighten the screws (2) fixing the connecting d caps to a torque of 60 Nm (6 kgm). Using tool 99395216 , tighten the screws further with an angle of 60 . Figure 180 60563 ing the centring ring 99396035 (2), check the exact sition of the cover (1). If it is wrong, proceed accordingly d lock the screws (3).
Figure 181 60564 y on the gasket (1), mount the key 99346250 (2) and, ewing down the nut (3), drive in the gasket (1).