F3B ENGINE 217 T RAKKER E URO 4/5 Fitting camshaft Figure 193 Figure 195 60570 - Apply the gauge 99395219 (1). Check and adjust the position of the link rod (3) for the idle gear. Lock the screw (2) to the required torque. 72436 Position the crankshaft with the pistons 1 and 6 at the top dead centre (T.D.C.). This situation occurs when: 1. The hole with reference mark (5) of the engine flywheel (4) can be seen through the inspection window. 2. The tool 99360612 (1), through the seat (2) of the engine speed sensor, enters the hole (3) in the engine flywheel (4). If this condition does not occur, turn the engine flywheel (4) appropriately. Remove the tool 99360612 (1).
Figure 194 Figure 196 73843 Fit the camshaft (4), positioning it observing the reference marks ( ) as shown in the figure. Lubricate the seal (3) and fit it on the shoulder plate (2). Mount the shoulder plate (2) with the sheet metal gasket (1) and tighten the screws (5) to the required torque. - Fit the idle gear (1) back on and lock the screws (2) to 60571 the required torque. Print 603.93.641 Base q November 2006