Iveco — 603.93.641-3Cp

218 F3B ENGINE T RAKKER E URO 4/5  Figure 197 Figure 199 5 60572 116724 Position the gear (2) on the camshaft so that the 4 slots are centred with the holes for fixing the camshaft, without fully locking the screws (5). Using the dial gauge with a magnetic base (1), check that the clearance between the gears (2 and 3) is 0.074 q 0.195 mm; if this is not so, adjust the clearance as follows: Mount: - The injectors (2) and, using a torque wrench, lock the bracket fixing screws to a torque of 30 35 Nm. - The exhaust brake cylinders (1) and (4) and, using a torque wrench, fix them to a torque of 19 Nm. - Loosen the screws (4) fixing the idle gear (3).

- Loosen the screw (2, Figure 195) fixing the link rod.Shift - The crosspieces (3) on the valve stem,all with the largest hole on the same side. the link rod (3, Figure 195) to obtain the required clearance. - Lock the screw (2, Figure 195) fixing the link rod and screws (4,Figure 197) fixing the idle gear to the required torque. Fitting rocker-arm shaft assembly Fitting pump-injectors NOTE Before refitting the rocker-arm shaft assembly, make sure that all the adjustment screws have been fully unscrewed. Figure 198 Figure 200 108843 Using tool 99360144 (3), fasten the blocks (4) to the rocker arms (2).

Apply the tool 99360553 (1) to the rocker arm shaft (5) and mount the shaft on the cylinder head. 73533 Fit the seals (1) (2) (3) on the injectors. Base q November 2006 Print 603.93.641