Iveco — 603.93.641-3Cp

Failing Type of Checks to be Measuring Values to be DTC FMI Visible failure Possible Cause Repair action Remarks component Failure performed conditions detected 232 COOL- Slight power re- Extreme envi- Ensure the engine is ANT TEM- duction ronmental working in non-critical PERATURE conditions or conditions. SENSOR sensor incor- Check the sensor con- ABSO- rectly adjusted. nections and accuracy. LUTE TEST Replace sensor if necessary. 238 OIL LOW Slight power re- Sensor incor- Check the sensor con- PRESSURE duction rectly adjusted nections and accuracy. or faults in lu- Check the lubrication brication system. system.

23A OIL TEM- Slight power re- Sensor incor- Check the sensor con- PERATURE duction rectly adjusted nections and accuracy. ABOVE or faults in lu- Check the lubrication NORMAL brication system. system. 27C BENCH 2 One or more in- Fault in control Replace the engine INJEC- jectors (bank 1 or unit. control unit. TORS bank 2) may not CHECK be operating (INTER- NAL ECU) 292 TURBINE Poor perform- VGT actuator or Check VGT wiring and ACTUA- ance wiring defective. actuator.

TOR CON- TROL ELECTRO- VALVE SHORT CIRCUIT TO GROUND 2A6 TIMEOUT No effect per- Problem in the Check the faults in the OF CAN ceived by the Denoxtronic Denoxtronic and con- MESSAGE driver (on the CAN sult the control unit SCR2 line). troubleshooting guide. Check wiring. DTC FMI Failing component Type of Failure Visible failure Possible Cause Repair action Checks to be performed Measuring conditions Values to be detected Remarks 232 COOL- ANT TEM- PERATURE SENSOR ABSO- LUTE TEST Slight power re- duction Extreme envi- ronmental conditions or sensor incor- rectly adjusted. Ensure the engine is working in non-critical conditions. Check the sensor con- nections and accuracy.

Replace sensor if necessary. 238 OIL LOW PRESSURE Slight power re- duction Sensor incor- rectly adjusted or faults in lu- brication system. Check the sensor con- nections and accuracy. Check the lubrication system. 23A OIL TEM- PERATURE ABOVE NORMAL Slight power re- duction Sensor incor- rectly adjusted or faults in lu- brication system. Check the sensor con- nections and accuracy. Check the lubrication system. 27C BENCH 2 INJEC- TORS CHECK (INTER- NAL ECU) One or more in- jectors (bank 1 or bank 2) may not be operating Fault in control unit. Replace the engine control unit.

292 TURBINE ACTUA- TOR CON- TROL ELECTRO- VALVE SHORT CIRCUIT TO GROUND Poor perform- ance VGT actuator or wiring defective. Check VGT wiring and actuator. 2A6 TIMEOUT OF CAN MESSAGE SCR2 No effect per- ceived by the driver Problem in the Denoxtronic (on the CAN line). Check the faults in the Denoxtronic and con- sult the control unit troubleshooting guide. Check wiring.