9 T RAKKER E URO 4/5 CLUTCH Print603. 93.641 505210 REMOVING AND REFITTING THE CLUTCH Figure 3 Removal This operation comprises: - Removing-refitting propeller shafts (see relevant section 505620). - Removing-refitting gearbox (see relevant section 530210). 40195 Remove the clutch disc (2) by removing at the same time the locating pin 99370264 or 99370280 (1). Checks The checks to make are as follows: - The supporting surface of the driven disc, on the engine Figure 1 flywheel, must not be particularly worn or have too much scoring. - The toothing of the ring gear of theengine flywheel must be neither deteriorated nor too badly worn.
If this is not the case, remove the engine flywheel (operation 540850). In addition, check there is not even the slightest leakage of lubricant from the seal of the crankshaft rear cover: in which case, remove the flywheel as described under the relevant heading. Remove the rear cover together with the seal and replace it as described in section 2. Check that the bearing or bushing supporting the gearbox input shaft mounted on the crankshaft is neither worn nor deteriorated, in which case it should be replaced. Fit the clutch locating pin 99370264 or 99370280 the support bearing of the transmission input shaft.
Check the state of the pressure plate, the supporting surface of the driven disc must have no deformation, wear or sign of overheating and its spring or diaphragm must be sound. Figure 2 Check the state of the driven disc: - the friction linings must not be too worn, nor have any - its hub must not have too much play on the gearbox sign of overheating, nor be fouled with oil or grease. input shaft. - the torsion springs of thehub must not turn in their seats or be broken. If you find any trouble at all, replace the part concerned. The clutch assembly is supplied as a spare in kit form. The following are supplied singly: - The driven disc and the thrust bearing.
Fit the mount 99370547 (1) on the hydraulic jack and apply the mount to the pressure plate (3). Unscrew the screws (2) and remove the pressure plate from the engine flywheel. In this caseit is necessary to mount the new parts of the same supply as the torsion spring being reused. Base - November 2006 Print 603.93.641 tion 210). 38438 into 40194 pply s (2) el.