Iveco — 603.93.641-3Cp

10 T RAKKER E URO 4/5 CLUTCH  Figure 4 Before fitting a new driven disc it is necessary to check its centring as follows: Position the driven disc (1) on a lathe. Then, with the aid of a dial gauge with a magnetic base (2), check that the surface of the disc is not off centre anywhere. The maximum permissible eccentricity of the driven disc is 0.20 mm. Figure 5 If the disc is off centre, use a fork wrench (1) as shown in the figure. Refitting Fit the clutch assembly back on by performing the operations described for removal in reverse order and observing the following instructions:

- Thoroughly clean the supporting surface of the clutch plate of the engine flywheel with spirits or petrol. Any light scoring you find on it can be removed with abrasive cloth. - Position the driven disc, always using the guide pin for perfect centring to prevent harmful stresses on the hub when refitting the gearbox. - Position the clutch plate by matching the holes for the fixing screws with the ones on the engine flywheel. - Mount and lock the fixing screws of the pressure plate to the required torque. - Fit the gearbox back on after spreading the splined shaft with Molikote molybdenum disulphide grease.

- Adjust the push rod of the operator c ylinder as described under the relevant headi ng (operation 505272). Base - November 2006 Print 603.93.641 50 Th - - Us be Re N 54 Th - - - Us Us be Fo Re 5254 REMOVING-REFITTING THE THRUST BEARING Figure 6 36800 is operation comprises: Removing-refitting propeller shafts (see relevant section 505620). Removing-refitting gearbox (see relevant section 530210). ing suitable pliers, open the snap ring (1), take the thrust aring (2) out of the pressure plate. verse these steps for fitting. OTE The new part has to be of the same supply as the pressure plate being reused.

0852 REPLACING THE SUPPORT BEAR- ING OF THE CLUTCH SHAFT Figure 7 40196 is operation comprises: Removing-refitting propeller shafts (see relevant section 505620). Removing-refitting gearbox (see relevant section 530210). clutch removal/refitting (operation 505210). ing the appropriate pliers remove the split ring (3). ing the universal extractor 99348004 (1) remove the aring (2). r refitting, use the appropriate beater. fit the split ring.