Iveco — 603.93.641-3Cp

18 T RAKKER E URO 4/5 CLUTCH Print603. 93.641/A  SPRING PIN ADJUSTMENT GEARBOX ASSEMBLY Figure 26 114974 NOTE Engines F2B with push clutch SACHS on gearboxes 9S 1310/11 TO do not need any adjustment. Engine F2B F3B Perform following operations: - measure dimension (A) between clutch lever spherical cavity and actuator fixing plane; Disengagement lever must rest against thrust bearing. NOTE It is necessary to observe this adjustment to make the worn plate indicator trip, which is located in the operator cylinder,closetothe completewear of the friction linings.

The plate wear (90% of the friction material) is indicated by a significant increase in load on the pedal when disengaging the clutch. - push ball spring pin up to stop (G) ; screw, or unscrew, spring pin (F) until dimension (B) is obtained. B = A - E (See values shown in below table). NOTE Should any oil leaks from the main cylinder and/or the clutch actuator be detected, replace the involved component and bleed the hy draulic system. Base - November 2006 Print 603.93.641/A Revi - June 2007 Clutch E (mm) Push clutch SACHS do not need any adjustment Pull clutches VALEO 30 Pull clutches VALEO 35