19 T RAKKER E URO 4/5 CLUTCH SPECIFICATIONS FOR GEARBOX ASSEMBLY EUROTRONIC 12 AS 1930/2330/2530 Figure 27 114975 A) Specifications for adjusting the clutch servo, when new 4. Fit the pushrod in the lever ball socket. and when the clutch is replaced: 1. Measure distance k A y between the clutch lever ball 5. Fit the clutch servo and secure using the four hex-headed socket base and the clutch servo fastening surface. The lever should be resting on the thrust bearing. bolts. Tightening torque 23 Nm. 6. Unscrew screw plug k H y and then retighten when the 2. Adjust the rod using the following e quation: L=A-(B-C) +33 and secure with locknut k F y. Tightening torque 52 Nm.
piston is forward. Tightening torque 25 Nm. 7. Connect electrical connector k D y and air delivery pipe NOTE - Measure dimension k B y with the clutch servo at the end of its travel (screw plug k H y open). - The clutch wear travel to the clutch servo, set using software, is standardised at 30 mm, corresponding to clutch plate wear of 3 mm (minimum guaranteed clutch plate wear). C) Replacing the clutch servo: k G y. If replacing the clutch servo alone, proceed as described under point B , leaving pushrod adjustment setting k L y unchanged. B) Fitting the clutch servo to the clutch casing: 1. Unscrew the screw plug k H y on the inspection hole to allow air to emerge from the inner chamber. 2.
Move the clutch servo piston back by hand to overcome the resistance of the internal spring. 3. Retighten plug k H y by hand to hold the piston back. ! Beforeconnecting the air pipe, ensure that the clutch servo is correctly fastened to the clutch casing. Base - November 2006 Print 603.93.641/A Revi - June 2007