20 T RAKKER E URO 4/5 CLUTCH SPRING PIN ADJUSTMENT GEARBOX EUROTRONIC 12 AS 1420 TD Figure 28 120466 In case of replacement of the clutch actuator, the previously set push rod length remains unvaried. The push rod adjustment only occurs when the driven disc or the disc pusher are replaced. NOTE Differently from ordinary operations, in case of vehicles equipped with 12 AS 1420 gearbox, instead of the wear level, the disconnecting stroke is adjusted. If the adjustment is not carried out correctly, the disc pusher is damaged. Push forwards the disconnecting fork (1) and measure height in yBy. Height C calculation C = B + 33 mm Example:
B = 57 mm C = 57 mm + 33 mm = 90 mm Height C adjustment Assemble the push rod (2) into the clutch actuator (3). Loosen the screw (4) on the clutch actuator (3) until the cylinder comes out. Measure the height yCy between the spherical head of the push rod and the bearing surface of the clutch actuator. Adjust the push rod to reach the height yCy . Insert the push rod (2) into the head of the disconnecting fork (1). Base - November 2006 Print 603.93.641/A Revi - June 2007