54 F2B ENGINE T RAKKER E URO 4/5 REPAIR OPERATIONS 47440 Ш 115 to 115.012 mm Ш 115.010 to 115.022 mm wear max 0.150 mm or maximum mm compared to the values indicated must be replaced as they cannot be liners are equipped with spare parts with class. 47441 130.225 mm 128.535 mm 130.186 to 128.500 mm inner diameters. Base q November2006 Print 603.93.641 540410 CYLINDER BLOCK 540420 Checks and measurements Figure 54 (Demonstration) 34994 Internal diameter of the cylinder liners is checked for ovalization, taper and wear, using a bore dial (1) centesimal gauge 99395687 (2) previously reset to ring gauge (3), diameter 115 mm.
Figure 56 NOTE If a 115 ring gauge is not available use a micrometer caliper. Figure 55 47439 1 = 1st measuring 2 = 2nd measuring 3 = 3rd measuring Carry out measurings on each cylinder liner at three different levels and on two (A-B) surfaces, to one another perpendicular, as shown in Figure.