PROCESS UNIT hp Color 9850mfp 5. Stand up the transfer belt unit [1] by using the front side of the transfer belt unit [1] as the bot- [3] [6] [2] 6. Remove the screw [2] and release the fixing of tom. the handle [3]. 7. Remove 2 screws [4] and then remove the shaft [7] 8. Remove the screw [6] and then remove the ten- stopper [5]. [5] [4] sion plate /R [7]. Note: III DIS./ASSEMBLY • When reinstalling the tension plate R, knock against the projection of the tension plate R. [12] [1] 9. Remove 2 screws [8] and then remove the high 10. Remove the stop ring [10] and then remove the voltage supply curler R [9]. [8] [11] bearing [11]. Note:
• When reinstalling the stop ring, be sure to raise the shaft so that the stop ring is set in the groove of the shaft. 11. Pull up the transfer belt [12] for removal. [9] [10] Note: • Be sure to reinstall the transfer belt so that the rear side stamped with "UP SIDE" at the edge of the belt comes up. • When holding the transfer belt by hand, hold it within 10mm from the upper end. Be careful not touch any part other than this. 12. Reinstall the above parts following the removal steps in reverse. Note: • Be careful not to touch and/or damage the transfer belt with bare hands. 3-42