Q5686A/Q5687A DISASSEMBLY/ASSEMBLY 3.2 Removing and reinstalling of the up / down wire Caution: • When removing the tray up/down motor, be sure to hold the main tray to prevent it from falling. Note: • The wire replacement steps shown below refer to those taken on the rear side. The shape and the winding of wire on the front side are symmetrically the same as those on • The wire brackets of the up/down wire is the rear side. stamped with "F" for the front side and "R" for the rear side. When reinstalling, be careful not to mix up the front with the rear. III DIS./ASSEMBLY A. Procedure 1. Remeve the following parts: • Side cover • Finisher door • Rear cover • Tray up/down motor (M703) 2.
Remove 5 screws [1], and then remove the up/ • Main tray down gear cover [2] and the gear [3]. [1] [2] 3-13 [3 ]