DISASSEMBLY/ASSEMBLY Q5686A/Q5687A 9. Set the pin [1] and the gear [2] to the shaft and fasten it with the E-ring [3]. [1] [2] [3] 10. Using a tension gauge or spring balance, pull the belt tensioner [1] to the specified force "A" and tighten it with 2 screws [2]. III DIS./ASSEMBLY Specified value: A = 2.5 ± 0.25 kg 11. Loosen 2 screws [2] of the wire bracket [1] on the front side. Press down the up/down stay [3] wire bracket [4] on the rear side and screws (4 to make it level, and tighten screws [5] of the screws in all). Note: • Be sure to check if the up/down stay [3] is level.
If it is out of the level, an undesirable load may be imposed on the tray up/down motor (M703) or the gear, causing damage to it. 12. Reinstall the above parts following the removal steps in reverse. 3-16 [2] [1] [4] [2] [1] [3] [5]