DISASSEMBLY/ASSEMBLY Q5686A/Q5687A 4. Remove 5 screws [1] and then remove the sta- pler unit cover [2]. 5. Reinstall the above parts following the removal steps in reverse. [1] [2] 5.2 Replacing the clincher Note: III DIS./ASSEMBLY • Do not use hands to move clincher units to horizontal direction. Otherwise the belt and the gear teeth skipping may occur. • After reinstalling the clincher, be sure to con- duct the "vertical adjustment of the finisher sta- pler."(See "ADJUSTMENT.") A. Periodically replaced parts/cycle • Clincher: Every 200,000 staples B. Procedure 1. Open the finisher door. 2. Pull out the stacker unit and remove the stapler unit cover. 3.
Remove a ground screw [1], and then remove [5] 4. After removing 4 screws [4], remove the clincher the ground [2] and the clamp [3]. /F [5] and then remove the connector [6]. [6] [4] [3] [2] [1] 3-22