TRAY UP/DOWN Q5690A 3.2 Removing and reinstalling the up / down wire A. Wire length: • Up/down wire A: 1450mm (4 wires) • Assist wire C: 1240mm • Assist wire D: 820mm B. Removing the wire Note: • Be sure to lower the up/down plate to its lower most position in advance by pressing the tray down switch (SW100) with electricity sup- plied. 1. Remove the HCI from the engine. 2. Remove the right side cover, front cover, clutch III DIS./ASSEMBLY 3. Remove the rear drive. replacement cover, and the rear cover. 4. Rotate the up/down drive shaft [1] clockwise as seen from the rear side to lift the up/down plate [2] [4] [11] [2] up to its upper most position. [10] Note:
• When the springs [3] and [4] are removed in [13] the succeeding steps, the up/down plate [2] comes down. For this reason, be sure to sup- port the up/down plate [2] by hands. (This work requires two persons.) [6] [12] [5] 5. Remove the spring [3] and then remove the [3] [1] assist wire C [5] from the guide pulleys [6] and [7] 6. [7]. After releasing the winding of the assist wire C [5] [10] [5] around the drive pulley [8], remove the E-ring [1] [9] and then remove the drive pulley [8]. [14] [15] 7. drive shaft [1]. Remove the assist wire C [5] from the up/down [1] [8] 8. Remove the spring [4] and then remove the [9] assist wire D [10] from the guide pulleys [11], 9. [12] and [13].
After releasing the winding of the assist wire D [10] around the drive pulley [14], remove the E- ring [15] and then remove the drive pulley [14]. 10. Remove the assist wire D [10] from the up/ down drive shaft [1]. 11. Bring down the up/drive plate [2]. 3-16