• Click Start and HP User Tools, then on the Information tab, click OmniBook System Information. To add memory to the OmniBook, see “Adding Memory to the OmniBook” . To replace the hard drive (drive C) You normally don’t remove drive C—that’s the main internal disk (also called the "hard-disk drive"). The two main reasons to replace drive C are for upgrade and for repair. Hint Print these instructions out so you can refer to them while doing the procedure. Caution If you’re replacing drive C, back up your files before replacing the drive. Otherwise, you won’t be able to restore files you’ve created or changed. Take precautions against damage from static electricity:
• • Gather all the parts you need so you can complete the installation in one sitting. • • Don't remove the drive from its packaging until you're ready to insert it. • • When you remove the drive from its packaging, hold it only by its edges. Close all applications, exit Windows, shut down the computer, unplug the ac adapter, and remove the battery before removing the hard drive. Otherwise, the OmniBook or the hard drive may be damaged. 1. Back up all the files on your current drive C. You can back up the files to a tape drive, a network drive, a PC card, or floppy disks.
Click Start, Programs, Accessories, System Tools, Backup, and then use the Backup tab to specify the backup source and the backup destination. 2. Important: Turn off the unit, unplug the ac adapter, and remove the battery. 3. Close the cover and turn your computer over. Using a Torx-T6 screwdriver, remove the five screws holding the hard drive and the keyboard in place (the exact locations vary with the type of hard drive). 52