Supermicro A+ Server 4022G-6F — Supermicro A+ Server 4022G-6F User's Manual PDF Download

A+ Server 4022G-6F User's Manual SGPIO The T-SGPIO1/ T-SGPIO2 (Serial General Purpose Input/Output) headers provide a bus between the SATA controller and the backpane to provide SATA enclosure management functions. Connect the appropriate cable from the backplane to the T-SGPIO1 header to utilize SATA management functions on your system. Note: NC indicates no connection. Unit Identifier Button There is a Unit Identifier (UID) button on the rear I/O of the board. There is also another UID button located on the control panel. When you push either UID button, both Rear UID and Front Panel UID Indicators will illuminate. Push either button again to turn off both indicators.

These UID indicators provide easy identification of a system unit that may be in need of service. Universal Serial Bus Ports Two Universal Serial Bus ports (USB 2.0) are located beside the Keyboard and Mouse PS2 ports (USB0/1). Two additional Type A ports (USB6/7) are also included on the motherboard. See the table on the right for pin definitions. USB Headers Four USB 2.0 headers (USB2/3 and USB4/5) are also included on the motherboard. These may be connected to provide front side access. A USB cable (not included) is needed for the connection. See the table on the right for pin definitions. Note: NC indicates no connection.

5-20 SGPIO Header Pin Definitions (T-SGPIO1/T-SGPIO2) Pin# Definition Pin # Definition 1 NC 2 Data 3 Ground 4 Data 5 Load 6 Ground 7 CLK 8 NC UID Button Pin Definitions Pin# Definition 1 Ground 2 Ground 3 Button In 4 Ground Universal Serial Bus Ports Pin Definitions (USB 0/1, USB6/7) USB0 Pin # Definition USB1 Pin # Definition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground Universal Serial Bus Headers Pin Definitions (USB2/3, USB4/5) JUSB2, JUSB3 Pin # Definition Pin # Definition 1 +5V 2 +5V 3 PO- 4 PO- 5 PO+ 6 PO+ 7 Ground 8 Ground 9 Key 10 NC