Chapter 5: Advanced Serverboard Setup LAN Enable/Disable Change the setting of jumper JPL1 to enable or disable the LAN1/2 Ethernet ports. See the table on the right for jumper settings. The default setting is enabled. SAS Enable/Disable JPS1 allows you to enable or disable the SAS controller on the H8DG6/H8DG6-F serverboards. The default position is on pins 1 and 2 to enable SAS. See the table on the right for jumper settings. VGA Enable/Disable JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings.
I2C to PCI-Express Slot JI2C1/JI2C2 allows you to enable the I 2 C bus to communicate with the PCI-Express slot. For the jumpers to work properly, please set both jumpers to the same setting. If enabled, both jumpers must be enabled. If disabled, both jumpers must be disabled. See the table on the right for jumper settings. BMC Jumper JPB1 is used to enable or disable theBMC (Baseboard Management Control) Chip and the onboard IPMI connection.This jumper is used together with the IPMI settings in the BIOS. The default position is on pins 1 and 2 to Enable BMC. See the table on the right for jumper settings.
5-23 LAN Jumper Settings (JPL1) Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled SAS Enable/Disable Jumper Settings (JPS1) Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled VGA Enable/Disable Jumper Settings (JPG1) Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled I2C to PCI-Express Slot Jumper Settings (JI2C1/JI2C2) Jumper Setting Definition Closed Enabled Open Disabled BMC Jumper Enable (JPB1) Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (default) Pins 2-3 Disabled