A90 series Inverter User Guide 60 F12.01 STOP key selection 0: Valid Only at Keypad Control 1: Valid at All Command Channels 1 〇 F12.02 Parameter Locking 0: Unlocked 1: All locked except Reference Input 2: All locked except this Parameter 0 ● F12.09 Speed Display Factor 0.01 - 600.00 30.00 ● F12.10 UP/DOWN key Rate 0.00: Automatic Rate 0.01 - 500.00 Hz/s 5.00 〇 F12.11 UP/DOWN Offset Clear 0: Not to Clear 1: Clear at Non-Running Status 2: Clear at Disabled UP/DOWN 1 〇 F12.12 Power Failure Save of UP/DOWN Offset 0: Disabled 1: Enabled (only at modified offset) 0 〇 F12.13 Kilowatt-Hour Meter Clear 0: Not to Clear 1: Clear 0 ● F12.14 Reset to Factory Defaults 0: No Function 1:
Reset (exclusive of motor parameter, inverter parameter, manufacturer parameter, running and power-on time record) 0 〇 F12.15 Accumulated Power-On Time hours 0～65535 h XXX × F12.16 Accumulated Power-On Time minutes 0～59 min XXX × F12.17 Accumulated Running Time hours 0～65535 h XXX × F12.18 Accumulated Running Time minutes 0～59 min XXX × F12.19 Inverter Rated Power 0.40～650.00 kW Model related × F12.20 Inverter Rated Voltage 60～690 V × F12.21 Inverter Rated Current 0.1～1500.0 A × F12.33 Display parameter 1 at running 0.00～99.99 （Stop status display parameters 5） 18.00 ● F12.34 Display parameter 2 at running 0.00～99.99 （Stop status display parameters 1） 18.01 ● F12.35 Display parameter 3 at running 0.00～99.99 （Stop status display parameters 2） 18.06 ● F12.36 Display parameter 4 at running 0.00～99.99 （Stop status display parameters 3） 18.08 ● F12.37 Display parameter 5 at running 0.00～99.99 （Stop status display parameters 4） 18.09 ●