User Manual of A90 Series Inverter 256 E03 Instantaneous overvoltage 1. The deceleration time is too short, and the motor has too much regenerated energy. 2. The braking unit or braking resistor forms an open circuit. 3. The braking unit or braking resistor does not match. 4. The power voltage is too high. 5. The energy consumption braking function is not enabled. 1. Increase the deceleration time. 2. Check the wiring of the braking unit and braking resistor. 3. Use a suitable braking unit/braking resistor. 4. Reduce the power voltage to the specified range. 5. For the model of the built-in braking unit, set F15.30 to 1, and enable the energy consumption braking.
E04 Steady-state overcurrent The same as E02 The same as E02 E05 Steady-state overvoltage Same with E03 Same with E03 E06 Steady-state undervoltage 1. The input power supply is subject to phase loss. 2. The terminals of the input power supply are loose. 3. The voltage of the input power supply drops too much. 4. The switch contacts of the input power supply are aging. 1. Check the input power supply and wiring. 2. Tighten the screws of input terminals. 3. Check the air circuit breaker and contactor. E07 Input phase loss 1. The input power supply is subject to phase loss. 2. The input power supply fluctuates greatly. 1. Check the input power supply. 2.
Check the wiring of the input power supply. 3. Check whether the terminal is loose 4. Use a voltage regulator on the input side. E08 Output phase loss 1. The output terminals U, V and W have phase losses. 1. Check the connection between the inverter and motor. 2. Check whether the output terminal is loose. 3. Check whether the motor winding is disconnected. E09 Inverter overload 1. The acceleration and 1. Increase the acceleration and