sinee — A90 User Manual

User Manual of A90 Series Inverter The recommended power and resistance for the braking resistor of the A90 series inverter are given in the table below. The recommended resistor power is calculated based on the braking rate (10% to 20%). It is for reference only. If the inverter is used in the case of frequent acceleration/deceleration or continuous braking, the power of the braking resistor needs to be increased. The user can change the value according to the load conditions, but within the specified range. ★ The wires listed above refer to the outgoing wires of a single resistor. If resistors are connected in parallel, the bus should be enlarged accordingly.

The withstand voltage of the wires should be AC300V or above for the single-phase model and AC450V or above for the three-phase model. Cables should be resistant to 105°C. 11.2 Braking Unit For the A90 series inverters (A90-4T60 and above), use our BR100 series braking units (power range: 18.5-160kW). The models of our braking units are as follows.

268 Wire (mm2) Motor Resistance Resistor Power Inverter Model Connected to (kW) (Ω) (W) Resistor A90-2T2R8B 0.4 ≥360 ≥200 1 A90-2T4R8B 0.75 ≥180 ≥400 1.5 A90-2T8R0B 1.5 ≥180 ≥400 1.5 A90-2T010B 2.2 ≥90 ≥800 2.5 A90-4T2R5B 0.75 ≥360 ≥200 1 A90-4T4R2B 1.5 ≥180 ≥400 1.5 A90-4T5R6B 2.2 ≥180 ≥400 1.5 A90-4T9R4B 4 ≥90 ≥800 2.5 A90-4T013B 5.5 ≥60 ≥1000 4 A90-4T017B 7.5 ≥60 ≥1000 4 A90-4T025B 11 ≥30 ≥2000 6 A90-4T032B 15 ≥30 ≥2000 6 A90-4T038B 18.5 ≥30 ≥2000 6 A90-4T045B 22 ≥15 ≥4000 6 Inverter Model Motor (kW) Resistance (Ω) Resistor Power (W) Wire (mm2) Connected to Resistor