AC100 HIGH-PERFORMANCE VC INVERTER MANUAL OVERVIEW 5 Torque upgrade capacitance Auto torque upgrade 0.0%～100.0% Manual torque upgrade 0.0%～30.0% V/F curve VF linear curve, custom multi VF curve, square VF curve; VF power 1.1-1.9 arbitrary curve; Acceleration/Deceleration curve Two ways: one linear acceleration and deceleration, S-curve acceleration and deceleration; Four sets of acceleration and deceleration time, time unit 0.01s, longest 650.00s, the benchmark optional; Rated output voltage Using the compensation function of power supply voltage.
When the motor rated voltage range is 100%, it can be set to any value within the range of 50-100% (output voltage can’t exceed the input voltage) Voltage auto-adjustment When the grid voltage fluctuates, the constant output voltage can be automatically maintained. Energy-saving running Depending on the load condition, automatically optimizing the output voltage to save energy. Current auto-limiting Auto-limit the current while running to prevent frequent over current break trouble. Instant power off treatment When instant power off, control the bus voltage to realize uninterrupted operation.
Standard functions Superposition of main and auxiliary frequency source, running the command bundle, starting frequency, vector pre-excitation starting, start / stop of DC braking, speed tracking and power-down re-starting, reverse ban and reversing dead time setting, zero speed torque holding, jog operation, frequency hopping, separately set the emergency stop time, FDT detection, timer function, torque control, flux braking and dynamic braking, failure recovery, the last three failure record, process PID controller, multi-velocity and PLC program control, 485 communication interface; Frequency setting channel Keyboard digital setting, keyboard potentiometer, analog voltage terminal VS, analog voltage / current terminals AI, analog current terminal AS, given and multi-channel communications terminal selection, main and auxiliary channel combinations Feedback input channel Voltage terminal VS1, the voltage / current terminals AI, current terminals AS, communication given, pulse input PUL Running command channel Operation panel given, external terminal given, communication given.
Input command signal Start, stop, FOR/REV, JOG, multi-velocity, free stop, reset, Acceleration/Deceleration time selection, frequency set channel selection, external fault alarm. External output signal 2 relay outputs, 1-collector output; 0 ~ 10V output, 4 ~ 20mA / 0 ~ 20mA output; Pulse frequency output;