Edge1MagnitudeConstraint Edge1MagnitudeConstraint VPARAMETER 5227 Indexed property used to set the magnitude constraint function. Two points are used: Base and Top. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5227, index_id, constraint_id) = value value = VPARAMETER (sequence_id, tool_id, 5227, index_id, constraint_id) V+ VPARAMETER (sequence_id, tool_id, 5227, index_id, constraint_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5227, index_id, constraint_id) Type Long Range Minimum: 0 Maximum: 255 Parameters ACE Reference Guide, 18317-000 Rev A Page 177 $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example:
192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 5227: the value used to reference this property. index id _ Index of the edge pair. Range [1, PairCount -1]. constraint id _ One of the two points of the magnitude constraint function (hsMagnitudeConstraintIndex) 1: Base point 2: Top point