Edge1PositionConstraint Edge1PositionConstraint VPARAMETER 5224 Indexed property used to set the position constraint function of the first edge of the selected pair. Four points are used: Base Left, Top Left, Top Right, Base Right. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5224, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5224, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5224, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5224, index_id, object_id) Type Double Range Minimum: 0.0 Maximum: 1.0 Parameters ACE Reference Guide, 18317-000 Rev A Page 181 $ip IP address of the vision server. Applies to V+ syntax only.
Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 5224: the value used to reference this property. index id _ Index of the edge pair. Range [1, PairCount -1]. object id _ N/A