FilterHalfWidth FilterHalfWidth VPARAMETER 5202 Half-width of the convolution filter used by the tool to compute an edge-magnitude curve from which edges are detected. This value should be set to a value approximately equivalent to the width of the edge, in pixels, as it appears in the image. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 5202, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5202, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5202, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5202, index_id, object_id) Type Long Range Minimum: 1 Maximum:
25 Parameters ACE Reference Guide, 18317-000 Rev A Page 227 $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 5202: the value used to reference this property. index id _ N/A object id _ N/A