MaximumAngleDeviation MaximumAngleDeviation VPARAMETER 5102 Maximum angular deviation allowed for a detected edge to be used to generate an entity hypothesis. Syntax MicroV+ VPARAMETER (sequence_id, tool_id, 5102, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5102, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5102, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5102, index_id, object_id) Remarks For an arc entity, the deviation is calculated between the tangent angle of the arc at points where the edge is matched to the arc. For a line entity, the Line Finder accepts a 20 degree deviation (default).
However, the tool uses the defined MaximumAngleDeviation value to test the hypothesis and refine the pose of the found line. Type Double Range Minimum: 0 degrees Maximum: 20 degrees Parameters ACE Reference Guide, 18317-000 Rev A Page 364 $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1.