OverrideTypeEnabled OverrideTypeEnabled VPARAMETER 5350 Enables or disables the OverrideType property. Syntax MicroV+ VPARAMETER (sequence_id, tool_id, 5350, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 5350, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 5350, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 5350, index_id, object_id) Type Long Range Parameters ACE Reference Guide, 18317-000 Rev A Page 422 Value State Description 1 Enabled The output image type is set based on the setting of OverrideType [5351]. 0 Disabled The output image type is automatically set to the same type as the input image.
$ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 5350: the value used to reference this property. index id _ N/A object id _ N/A