SamplingStepCustom SamplingStepCustom VPARAMETER 124 When SamplingStepCustomEnabled is set to True, this property defines the sampling step used to sample the region of interest from the input image. WhenSamplingStepCustomEnabled is set to False, the default sampling step is used. Syntax Micro V+ VPARAMETER (sequence_id, tool_id, 124, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 124, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 124, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 124, index_id, object_id) Remark A custom sampling step is usually not recommended. Type Single Range Minimum: Greater than zero. Maximum:
Boundaries of the input image. Parameters ACE Reference Guide, 18317-000 Rev A Page 463 $ip IP address of the vision server. Applies to V+ syntax only. Uses standard IP address format, for example: 192.168.1.120. sequence id _ Index of the vision sequence. The first sequence is 1. tool id _ Index of the tool in the vision sequence. The first tool is 1. ID 124: the value used to reference this property.