Configuring NTP These following sections provide configuration information on NTP: Default NTP Configuration shows the default NTP configuration. Table 3: Default NTP Configuration NTP is enabled on all interfaces by default. All interfaces receive NTP packets. Configuring NTP Authentication To configure NTP authentication, perform this procedure: Procedure Administering the Device Configuring NTP Command or Action Purpose Device# copy running-config startup-config Feature Default Setting NTP authentication Disabled. No authentication key is specified. NTP peer or server associations None configured. NTP broadcast service Disabled; no interface sends or receives NTP broadcast packets.
NTP access restrictions No access control is specified. NTP packet source IP address The source address is set by the outgoing interface. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 [no] ntp authenticate Enables NTP authentication. Administering the Device 13