cisco — Configuring Broadcast-Based NTP Associations

Procedure Administering the Device Configuring Broadcast-Based NTP Associations Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-id Example: Device(config)# interface gigabitethernet1/0/1 Configures an interface and enters interface configuration mode. Step 4 [no] ntp broadcast [version number] [key key-id] [destination-address] Example: Device(config-if)# ntp broadcast version 2 Enables the interface to send NTP broadcast packets to a peer. • number: NTP version number. The range is 1 to 4.

By default, version 4 is used. • key-id: Authentication key. • destination-address: IP address of the peer that is synchronizing its clock to this switch. Use the no form of this command to disable the interface from sending NTP broadcast packets. Step 5 [no] ntp broadcast client Example: Device(config-if)# ntp broadcast client Enables the interface to receive NTP broadcast packets. Use the no form of this command to disable the interface from receiving NTP broadcast packets. Step 6 exit Example: Device(config-if)# exit Returns to privileged EXEC mode. Administering the Device 17