cisco — Creating an Access Group and Assigning a Basic IP Access List

Configuring NTP Access Restrictions You can control NTP access on two levels as described in these sections: Creating an Access Group and Assigning a Basic IP Access List To create an access group and assign a basic IP access list, perform this procedure: Procedure Administering the Device Configuring NTP Access Restrictions Command or Action Purpose Step 7 [no] ntp broadcastdelay microseconds Example: Device(config)# ntp broadcastdelay 100 (Optional) Change the estimated round-trip delay between the device and the NTP broadcast server The default is 3000 microseconds. The range is from 1 to 999999.

Use the no form of this command to disable the interface from receiving NTP broadcast packets. Step 8 end Example: Device(config)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 [no] ntp access-group {query-only | serve-only | serve | peer} access-list-number Example: Device(config)# ntp access-group peer 99 Create an access group, and apply a basic IP access list.. • query-only: NTP control queries. • serve-only: Time requests. • serve:

Allows time requests and NTP control queries, but does not allow the device to synchronize to the remote device. Administering the Device 18