NC Error Codes Diagnostics 71 Version: 1.0 Error(Hex) Error(Dec) Error Type Description 4239 16953 Parameter "Start type not allowed" The start type supplied does not exist. 423A 16954 Monitoring "Velocity overflow (overshoot in the velocity)" The new dynamic with the parameterized jerk is so weak that a velocity overflow will occur (overshoot in the velocity). The command is therefore not supported. 423B 16955 Parameter "Start parameter for the axis structure is invalid" External or internal parameters for the start structure for a positioning task are invalid.
Thus, for instance, the scaling factor, the SAF cycle time or the requested velocity may be less than or equal to zero, which is not allowed. 423C 16956 Parameter "Override generator initialization parameter invalid" One of the override generator (re)initialization parameters is invalid. 423D 16957 Monitoring "Slave axis has not set value generator" (INTERNAL ERROR) It is found that a slave axis within a group does not have a valid slave generator (set value generator). A slave axis and a slave set value generator must always be present as a pair. This is an internal error. 423E 16958 Function "Table is empty" Either the SVB table or the SAF table does not contain any entries.
423F 16959 Function "Table is full" The SVB table or the SAF table has no more free lines. 4240 16960 Memory "No memory available" SVB memory allocation for dynamic entry in SAF table failed. 4241 16961 Function "Table already contains an entry" (INTERNAL ERROR) SAF table entry abandoned, because, incorrectly, an entry already exists. 4242 16962 Function "Stop is already active" The stop instruction is not forwarded, because it has already been activated. 4243 16963 Function "Compensation has not been carried out over the full compensation section" The compensations start parameters do not permit compensation over the full section to be compensated.
For this reason the compensation will be carried out over a smaller section. 4244 16964 Parameter "Internal parameters for the compensation are invalid" (INTERNAL ERROR) Invalid internal parameters or start parameters of the lower-level generator. 4245 16965 Function "Compensation active" Start of compensation refused, because compensation is already active. It's also possible that the M/S axes are not active moved. Therefore an execution of the compensation is impossible. 4246 16966 Function "Compensation not active" Stop of compensation refused, because compensation is not active. 4247 16967 Function "Compensation type invalid" The type supplied for the section compensation is invalid.
At the present time only compensation type 1 (trapezoidal velocity profile) is allowed. 4248 16968 Function "Axis address for compensation invalid" (INTERNAL ERROR) The address of the master of slave axis on which the section compensation is to act is invalid. This is an internal error. 4249 16969 Address "Invalid slave address" (INTERNAL ERROR) The slave address given for on-line coupling/decoupling is invalid. 424A 16970 Function "Coupling velocity invalid" The velocity of what is to become the master axis is 0, which means that on-line coupling is not possible.