D ISARMING A SYSTEM AFTER AN ALARM The bell and the flashing light are activated when an alarm is triggered in the system. If your system has the option, a report of the event is automatically sent over the phone lines to a central station. If you inadvertently activate an alarm, immediately telephone the central station to prevent an unnecessary response. When you enter the premises after an alarm, the bell may already be silent if it has been so programmed. This allows there to be several alarms. Remember to record the fault or alarm in your logbook for future reference. 1. Go to the keypad. The entry period starts as soon as you open the entrance door, or when you enter the entry zone.
You can switch off the system without activating the alarm as long as the beeping continues. The red ALARM LED is lit on the control panel. Beep Beep The current day, date and time are displayed. An example is shown. TUE 23 APR 07.39 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press. Use the 0 key to cancel an incorrect entry and to restart a new entry code. Enter Code 0 + code Enter Code **** Disarm? 3. Press the Accept key. ! A list of triggered zones will be displayed. Events in Log... In this example, the alarm was triggered in zone 4 ‘Back Door’ on 23 April at 5.20 am in area 1. 004 Alarm 004 Back Door 23 APR 05.20 A1 4.
Press the Accept key to confirm the alarm. ! System Disarmed TUE 23 APR 07.40 Step 3 above may be automated by the system. If so, you will not have to press the Accept key. RECORD THE FAULT OR ALARM IN YOUR LOGBOOK ! Page 10 User Manual for CD72/95/15003