U SING A SPLIT SYSTEM When the system was installed it was divided into different security areas. A system that has more than one security area it is called a split system. These different areas were programmed by the installer. Depending on how the system was programmed, your code may give you access to one or more of the security areas. Depending on how the system has been programmed, you may not need to do all the steps shown in the instructions. If you enter the wrong code 10 times consecutively, the system is automatically locked for 90 seconds. During this time you cannot access the system. A split system has two different standby displays.
This is the display you see when you approach the keypad. They are called ‘Time/Date display’ and ‘Status display.’ The installer programmes one of these versions in your system. Time/Date display: It shows the current day, date and time. The system can also be programmed to present a second display to show a message, such as your company name for example. TUE 23 APR 07.40 Status display: It shows all the areas in the system (up to eight) and their security status. There are five different labels to identify the status of an area. If there are more than four areas, they will be shown in a second display. [ 1 ] =2= 4 [ 1 ] square brackets. The area is armed. [ 1 ] (number flashing).
Area number displayed is in alarm. =2= equal signs. The area is being armed (the exit time is still operating). pointed brackets. The area is partially armed (partguard). After entering your code, you will see one of two ‘selection’ messages. Which message you get depends on which one the installer programmed. They are as follows: 1. The system lists the status of each area, one display per area. At the end of the list you can enter the area number you want to Area 1 Armed 4 no brackets. The area is disarmed. access. If you do not enter a number, the standby display will reappear. Area 2 Disarmed Enter Area No. OR 2.
The system lists the status of all the disarmed areas (underscore scrolls underneath the numbers). If there are more than four areas, [ 1 ] 2 4 they will be shown in a second display. You can then enter the area number you want to access. If you do not enter a number, the standby display will reappear. Enter Area No. User Manual for CD72/95/15003 Page 11