U SING A SINGLE ALARM SYSTEM This chapter explains how to switch on and off an alarm system for premises with only one alarm system. These instructions also apply to users who only have access to a single alarm system in the premises, although several systems may actually be present. Depending on how the system has been programmed, you may not need to do all the steps shown in the instructions. If you enter the wrong code 10 times consecutively, the system is automatically locked for 90 seconds. During this time you cannot access the system. A RMING A SYSTEM Before you can arm, that is switch on, the alarm system, all intrusion zones must be secure.
If a zone in the premises is ‘open,’ that is its doors, windows, etc. are not properly closed, you will not be able to set the alarm in that zone, and the message ‘Open zones’ will appear on the display. It will also show you which zone(s) are open. You must then check that the doors, windows, etc. protected by the zone(s) shown on the display are properly closed. 1. Go to the keypad. The current date and time appear on the display. An example is shown. TUE 23 APR 07.39 2. Press the key 0 and then enter your code. A ‘*’ appears in the display for every key you press. Use the 0 key to cancel an incorrect entry and to restart a new entry code. Enter Code 0 + code Enter Code **** Arm Menu 3.
Press the Accept key. ! Normal Set 4. Press the Accept key again. ! If the system cannot be armed because there are area(s) in the premises which are not properly secured, the message ‘Open Zone(s) ’ will appear and a list of the zone(s) not closed. Press the 0 key to quit and check the doors, windows, etc. of the zone(s) identified. Normal Set " For information about excluding open zones, refer to the section ‘Arming a system which has open zones’ on page 8. The alarm is being set. System Arming The buzzer begins to beep. You must now exit the protected area by the designated route. Leave now User Manual for CD72/95/15003 Page 7