AH Motion Controller – Hardware Manual 5.3 Periodic Maintenance Under the condition that the daily inspection is undertaken, users are suggested that they should carry out the periodic Motion system conform to the cautions listed in section 5.1, users then can undertake the periodic inspection described maintenance according to the actual operating environment. After making sure that the ambient environment and the AH below. If any abnormal situation occurs, please follow the suggested actions and carry out the maintenance.
5.3.1 Tools Required for Inspection A screwdriver Industrial alcohol A clean cotton cloth A multimeter A thermometer A hygrometer 5.3.2 Periodic Inspection _5 5-4 No. Item Inspection Criterion Action 1 Ambient environment Ambient temperature/hu midity The ambient temperature and the ambient humidity are measured by a thermometer and a hygrometer. The ambient temperature and the ambient humidity must conform to the specifications for the modules or the backplane. If the specifications are different, the strictest specifications have high priority. To ensure that the system operates in a stable environment, check the reason why the environment varies, and correct it.
Atmosphere Measure corrosive gas. Corrosive gas must not be present. 2 Supply voltage Measure the AC power supply. The power supply should meet the specifications for the power supply module. Check the power supply. 3 Installation Looseness Check whether the module is loose. The module must be installed firmly. Please refer to chapter 4 for more information about installing the module. Adhesion of dirt Check the appearance. Dirt must not be present. Remove the dirt. 4 Connection Looseness of terminal screws Tighten the screws with a screwdriver. The screws must not be loose. Further tighten the screws. Looseness of connectors Pull the connectors. The connectors must not be loose.
Further tighten the screws on the connectors. 5 PLC system diagnosis Check the error logs. No new error occurs. Please refer to AH Motion Controller – Operation Manual for more information regarding troubleshooting and error logs.