AH Motion Controller – Operation Manual 9.3.4. BUS FAULT Indicator Blinking If the BUS FAULT indicator blinks, check the operating state of the module. Refer to section 9.4 for more information about the indicators behaviors of each module, and refer to the following content of this section for more information about the troubleshooting for I/O modules. _9 9-52 Error Code Description Corrective action 16#0013 The I/O module can not run/stop. (SM10) Check whether the setting of the parameter for the module is correct. If the setting is correct, please check whether the module breaks down. If the error still occurs, please contact the manufacturer.
16#0014 The procedure of restoring the system can not be executed. (SM9) The contents of the system backup file are incorrect, or the file does not exist in the path specified. If the file exists and the procedure of restoring the system can not be executed, please backing up the system again. If the error still occurs, please contact the manufacturer. 16#1401 An error occurs when the data in the I/O module is accessed. (SM9) Please contact the factory. 16#1402 The actual arrangement of the I/O modules is not consistent with the module table. (SM9) Check whether the module table in HWCONFIG is consistent with the actual arrangement of the I/O modules.
16#1403 An error occurs when the data is read from the module. (SM9) Check whether the module operates normally. If the error still occurs, please contact the factory. 16#1405 The setting parameter of the module is not found. (SM9) Set the parameter in HWCONFIG again, and download it. 16#140B The number of network modules exceeds the limit. (SM9) Please decrease the number of network modules to the number supported by the system. 16#140C The checksum of the high-speed data exchange is incorrect Please check the version of the firmware installed on the module, and contact the factory.
16#140D The ID of the actual power supply module is not the same as the ID of the power supply module set in HWCONFIG. Check whether the power supply configuration in HWCONFIG is consistenet with the actial arrangement of the power supply module. 16#140E The amount of data exchanged at a high speed exceeds the maximum amount supported. Check the firmware version and contact the supplier. 16#140F High-speed data exchange error Check the firmware version and contact the supplier.