Chapter 9 Troubleshooting 9.4 Troubleshooting for I/O Modules 9.4.1. Analog I/O Modules and Temperature Measurement Modules 9_ 9-65 Error Code Description Corrective action 16#9B5A COM2 receives no response from slave 26 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B5B COM2 receives no response from slave 27 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B5C COM2 receives no response from slave 28 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged.
16#9B5D COM2 receives no response from slave 29 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B5E COM2 receives no response from slave 30 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B5F COM2 receives no response from slave 31 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B60 COM2 receives no response from slave 32 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged.
Error code Description Corrective action 16#A000 The signal received by channel 0 exceeds the range of inputs which can be received by the hardware. (The ERROR LED indicator blinks.) Check the module parameter in HWCONFIG. Check whether the signal received by channel 0 exceeds the range of inputs which can be received by the hardware. 16#A001 The signal received by channel 1 exceeds the range of inputs which can be received by the hardware. (The ERROR LED indicator blinks.) Check the module parameter in HWCONFIG. Check whether the signal received by channel 1 exceeds the range of inputs which can be received by the hardware.
16#A002 The signal received by channel 2 exceeds the range of inputs which can be received by the hardware. (The ERROR LED indicator blinks.) Check the module parameter in HWCONFIG. Check whether the signal received by channel 2 exceeds the range of inputs which can be received by the hardware.